ECX Ruckus Bedienerhandbuch PDF herunterladen (Seite 3)

ruckus

WATER-RESISTANT VEHICLE WITH WATERPROOF ELECTRONICS

Your new Horizon Hobby vehicle has been designed and built with

a combination of waterproof and water-resistant components to

allow you to operate the product in many “wet conditions”,

including puddles, creeks, wet grass, snow and even rain.

While the entire vehicle is highly water-resistant, it is not completely

waterproofandyourvehicleshouldNOTbetreatedlikeasubmarine.

The various electronic components used in the vehicle, such as the

Electronic Speed Control (ESC), servo(s) and receiver are waterproof,

however, most of the mechanical components are water-resistant

and should not be submerged.

Metal parts, including the bearings, hinge pins, screws and nuts, as

well as the contacts in the electrical cables, will be susceptible to

corrosion if additional maintenance is not performed after running in

wetconditions.Tomaximizethelong-termperformanceofyourve-

hicle and to keep the warranty intact, the procedures described in the

“Wet Conditions Maintenance” section below must be performed

regularly if you choose to run in wet conditions. If you are not willing

to perform the additional care and maintenance required, then you

should not operate the vehicle in those conditions.

CAUTION:Failuretoexercisecautionwhileusingthis

product and complying with the following precautions

could result in product malfunction and/or void the warranty.

General Precautions

• Readthroughthewetconditionsmaintenanceprocedures

and make sure that you have all the tools you will need

to properly maintain your vehicle.

• Notallbatteriescanbeusedinwetconditions.Consultthe

battery manufacturer before use. Caution should be taken

when using Li-Po batteries in wet conditions.

• Mosttransmittersarenotwater-resistant.Consultyour

transmitter’s manual or the manufacturer before operation.

• Neveroperateyourtransmitterorvehiclewherelightning

may be present.

• Donotoperateyourvehiclewhereitcouldcomeincontact

with salt water (ocean water or water on salt-covered roads),

contaminated or polluted water. Salt water is very conductive

and highly corrosive, so use caution.

• Evenminimalwatercontactcanreducethelifeofyourmotor

if it has not been certified as water-resistant or waterproof. If

themotorbecomesexcessivelywet,applyverylightthrottle

until the water is mostly removed from the motor. Running a

wet motor at high speeds may rapidly damage the motor.

• Drivinginwetconditionscanreducethelifeofthemotor.

Theadditionalresistanceofoperatinginwatercausesexcess

strain. Alter the gear ratio by using a smaller pinion or larger

spur gear. This will increase torque (and motor life) when

running in mud, deeper puddles, or any wet conditions that will

increasetheloadonthemotorforanextendedperiodoftime.

Wet Conditions Maintenance

• Drainanywaterthathascollectedinthetiresbyspinningthem

at high speed. With the body removed, place the vehicle upside

down and pull full throttle for a few short bursts until the water

has been removed.

CAUTION:Alwayskeephands,ngers,toolsandany

loose or hanging objects away from rotating parts when

performing the above drying technique.

• Removethebatterypack(s)anddrythecontacts.Ifyouhavean

air compressor or a can of compressed air, blow out any water

that may be inside the recessed connector housing.

• Removethetires/wheelsfromthevehicleandgentlyrinse

the mud and dirt off with a garden hose. Avoid rinsing the

bearings and transmission.

NOTICE: Never use a pressure washer to clean your vehicle.

• Useanaircompressororacanofcompressedairtodry

the vehicle and help remove any water that may have

gotten into small crevices or corners.

• Spraythebearings,drivetrain,fastenersandothermetal

parts with a water-displacing light oil or lubricant. Do not

spray the motor.

• Letthevehicleairdrybeforeyoustoreit.Water(andoil)

may continue to drip for a few hours.

• Increasethefrequencyofdisassembly,inspectionand

lubrication of the following:

•Frontandrearaxlehubassemblybearings.

•Alltransmissioncases,gearsanddifferentials.

•Motor—cleanwithanaerosolmotorcleanerandre-oil

the bushings with lightweight motor oil.

Transmitter

Frequency 2.4GHz

Modulation DSM, DSM2, DSMR, Marine

Battery AAx4

Servo

Power Supply 4.8V~6V (shared with receiver)

OutputTorque 41.66oz(3kg-cm)

OperatingSpeed 0.23sec/60degreesoftravel

Size 55.6x20.1x35.6mm

Electronic Speed Control (ESC)

Input Voltage 6.0–8.4 V

Electric Capacity (FET) Forward 40A/180A

Electric Capacity (FET) Reverse 20A/90A

PWM Frequency 1kHz

BEC Voltage 5V/2A

Size 36x31.7x18mm

Weight 65 g

SPECIFICATIONS

1 2 3 4 5 6 7 8 ... 13 14

Kommentare zu diesen Handbüchern

Keine Kommentare

ECX Ruckus Bedienerhandbuch Seite 3

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Ferngesteuertes Spielzeug ECX Ruckus