ECX Torment Bedienerhandbuch PDF herunterladen (Seite 9)

TORMENT

MAINTENANCE

ELECTRONIC SPEED CONTROL (ESC)

NOTICE: The ESC (DYN4925WP) is compatible with NiCd and

NiMH batteries only. Not for use with LiPo or LiFe batteries.

Programming: This is an auotprogramming ESC. The ESC auto-

programs each time the vehicle is turned on.

SETTING THE GEAR MESH

The gear mesh has already been set at the factory. Setting the

gear mesh is only necessary when changing motors or gears.

You must remove the vehicle’s gear cover (A) to make this

adjustment.

Proper gear mesh (how the gear teeth meet) is important to the

performance of the vehicle. When the gear mesh is too loose, the

spur gear could be damaged by the pinion gear of the motor. If

the mesh is too tight, speed could be limited and the motor and

ESC will overheat.

Set the gear mesh by following these simple steps:

1. Loosen the 2 motor screws (B).

2. Put a small piece of paper (C) between the pinion and spur

gears.

3. Push the gears together while tightening the motor screws.

4. Rotate the gears to remove the paper. The gearing should

move a small amount.

5. Reinstall the gear cover.

ELECTRICAL LAYOUT

For correct operation, Channels 1 and 2

must be used as shown in the wiring diagram.

The motor can be disconnected from the ESC

at the connectors in the wiring.

Part # Description

A DYN1172

Motor

DYN1050EC Battery 7.2V

C ECX13000

Waterproof Steering

Servo

D SPMSR201

Receiver

E DYN4925WP

Waterproof Electronic

Speed Control (ESC)

Channel 1

Channel 2

Operation LED Color LED Status Sound

Stop Solid Green ON

Forward All OFF

Forward (full speed) Red ON

Reverse All OFF

Reverse (full speed) Green ON

Brake All Solid ON

Overheat All LEDs LEDs alternately ﬂ ashing 1 beep per second

Motor Stalled Red LED Flashing quickly 3 times, stopping, then repeating 1 beep per second

Battery Over Voltage (over 9V) All LEDs Solid Red LED. Green LED ﬂ ashing once per second 1 beep per second

Battery Under Voltage (4.5V) All LEDs Solid Green LED. Red LED ﬂ ashing once per second 1 beep per 5 seconds

EC3EC3

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 17 18

Kommentare zu diesen Handbüchern

Keine Kommentare

ECX Torment Bedienerhandbuch Seite 9

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Ferngesteuertes Spielzeug ECX Torment